Screen printing is a standard step in solar cell metallization, but the process itself can degrade device performance, and the risk is greatest for copper-plated silicon heterojunction (HJT) cells that are being pursued as a route to lower metallization costs and reduce reliance on silver. A team of researchers in China has now tied the loss to a specific mechanical cause and proposed a low-cost screen modification to contain it.
The concern is that the mechanical pressure and thermal treatments involved in printing can damage the sensitive passivating contact structures of HJT cells, raising recombination losses and pulling down conversion efficiency. The group set out to establish which part of the process was responsible and how the damage could be limited without compromising the printing step itself.
Photoresist printing is not silver printing
Corresponding author Lang Zhou told pv magazine that the two applications behave very differently. In silver paste printing, screen openings account for only 2–5% of the total area and the remaining surface is covered by an emulsion layer that keeps the mesh from touching the wafer. Full-area photoresist coating, by contrast, typically uses a screen without emulsion coverage so that resist is deposited uniformly across the whole wafer — which means the mesh comes into direct and extensive contact with the wafer on every printing cycle.
Wear tracked across 15,000 cycles
Earlier investigations cited by the team had already recorded a gradual efficiency decline from 26.2% to 25.7% over 15,000 consecutive printing cycles in commercial solar cell production. The losses appeared mainly as reductions in open-circuit voltage and fill factor, while short-circuit current density and electrical resistance stayed largely unchanged. Minority carrier lifetime degradation rose from 0.61% with a new screen to 11.0% after 15,000 cycles.
Using three-dimensional confocal microscopy, the scientists identified progressive wear of the screen mesh knuckles as the main driver. As the knuckles wore down, their contact area with the wafer increased, placing greater mechanical stress on the passivation layers underneath. Scanning electron microscopy revealed no visible surface scratches, but photoluminescence measurements confirmed higher recombination losses, pointing to damage at the amorphous silicon/crystalline silicon interface.
An emulsion buffer, and a trade-off
To break the direct contact, the researchers added an emulsion buffer layer to the screen and evaluated six patterns with emulsion coverage ratios ranging from 2.9% to 16.6%. The results exposed a trade-off between mechanical protection and photoresist coating uniformity: higher emulsion coverage reduced damage but impaired ink distribution.
A coverage ratio of 4.7% provided the best balance, holding minority carrier lifetime degradation to 0.41% after 10,000 printing cycles while maintaining relatively good coating uniformity. The team attributed the improvement to the emulsion layer preventing contact between the screen mesh and the wafer surface, thereby limiting cumulative mechanical damage to the sensitive passivation layers.
“The findings demonstrate that a relatively simple modification to screen design can substantially mitigate printing-induced degradation, offering a practical approach to improving the manufacturing reliability of copper-plated HJT solar cells,” Zhou said. The work was published in Solar Energy as “Screen-printing photoresist induced efficiency degradation and mitigation in Cu-plated SHJ solar cells.”
Copper contacts gain ground
The study lands amid growing interest in copper metallization as an alternative to silver-based contacts in HJT cells. In April 2026, researchers at China’s Nankai University reported a silver-free HJT cell with 25.2% efficiency, combining plasma-induced interface engineering with copper electroplating and addressing adhesion, contact resistance and stability challenges at the ITO interface. Separately, scientists at Germany’s Forschungszentrum Jülich reached 23.08% with a fully copper-metallized HJT cell — a relatively small efficiency penalty against its silver-metallized counterpart — while cells pairing silver-copper paste on the front side with silver contacts on the rear reached 23.95%. Those results underline copper’s potential to reduce silver consumption, although further improvements in processing and electrical performance remain necessary.
