Jeep Builder Flips a Rear Differential to Create a Cut-Price Portal Axle

Zeph Gage pairs a Ford 9-inch housing with Humvee geared hubs and an inverted differential to add rear clearance for roughly a fifth of typical portal-axle cost.

Off-road builder Zeph Gage has put together a low-cost portal axle for the rear of his Jeep Cherokee XJ by mounting a conventional differential upside down, an approach that substitutes careful fabrication for expensive off-the-shelf hardware.

Portal axles are valued in hardcore four-wheeling because they place a stack of gears behind each driven wheel instead of letting axle shafts and other components hang below the frame. The layout lifts the vehicle and tucks the driveline high, creating room for tall tires and leaving far less hardware to snag on rocks, whether the terrain is Moab slickrock or volcanic ground. As The Drive's Andrew Collins has described it, the concept is simple but the execution is spectacular, with enough clearance beneath a parked truck for a picnic.

The obstacle is cost. A typical set of portal axles from specialists such as 74Weld runs about $20,000. Gage's single rear unit comes in at roughly a fifth of that, built around a Ford 9-inch axle housing, geared hubs sourced from a Humvee and a set of HMMWV portal adapters from Jesse Haines Fabrication.

Correcting the direction of drive

Two-gear portals of the Humvee type reverse the rotation of the input shaft. To compensate with a Ford 9-inch, Gage flipped the differential upside down so the driveline turns the correct way. A Yukon Gear and Axle third member is then bolted to the inverted housing, in effect converting low-pinion parts into a high-pinion assembly.

According to the build, the arrangement adds about six inches of clearance while retaining full shock travel, a combination that is difficult to achieve with portal axles, and it reduces stress on the differential itself. Gage describes the result as effectively bulletproof.

Why only the rear axle

Fitting a portal at the back without matching hardware at the front is a familiar technique in the radio-controlled rock-crawler scene. Keeping the solid front axle lets Gage avoid the packaging constraints that appear when portals are added to a vehicle that never left the factory with them. It also means he does not have to limit shock travel, and ride height is not pushed absurdly high, which the builder frames as a best-of-both-worlds compromise.

Custom fabrication

The conversion is not a bolt-on kit. Gage made homemade brackets and custom-tapped plates, and paired a two-piece brake rotor with a Ford Fusion caliper. The Fusion hardware was selected partly for its integrated electric parking-brake solenoid and partly for clearance reasons.

The finished XJ can drive over a five-gallon bucket and still leave several inches of spare clearance, so the rear end is less likely to hang up on obstacles that the front can simply steer around. Gage directs viewers to the full video from Outdoor Auto for further specifics, including how front and rear gearing were matched.

NV

Nerea Valdes

Nerea covers exterior protection and styling accessories, including vehicle covers, mud flaps, window deflectors, running boards, and fender flares, as an exterior fitment and weathering editor. Her assessments connect year-make-model and body configuration data with installation clearance, UV and moisture exposure, surface contact points, fastener corrosion, and documented load limits. She helps aftermarket category buyers, accessory distributors, fleet procurement teams, and installation shops verify fitment evidence, weathering test methods, packaging protection, and return-risk drivers before listing or specifying an exterior part.