WITT Gas Controls to Present MEM+ Gas Mixers and Safety Valves at FABTECH 2026

The gas safety, control and analysis supplier will use Booth S46114 to discuss mixing, pressure regulation and valve hardware for industrial gas systems.

WITT Gas Controls will exhibit at FABTECH 2026, held October 21–23 at the Las Vegas Convention Center in Las Vegas, Nevada, and will use Booth S46114 to discuss its MEM+ gas mixers, dome pressure regulators and gas safety valves. The company, which describes itself as a global leader in gas safety, control and analysis solutions, is framing the lineup around three requirements: precise mixing, stable pressure and system protection.

Mixing accuracy in the MEM+ series

The MEM+ series mixes two or three non-flammable gases — nitrogen, carbon dioxide or oxygen among them — across a range of industrial applications. Electronically operated motorized proportional valves adjust in 0.1 percent increments, and the company says the desired mixture is reached in less than three seconds with accuracy better than ±1% absolute.

Seven interface options, including Ethernet, OPC UA and PROFINET, support integration into existing systems. Users can operate the mixers remotely through a PC, PLC or machine controller, or directly through a touchscreen interface.

Several functions are intended to keep operation stable. Pressure equalization compensates for supply pressure fluctuations, continuous inlet pressure monitoring and pressure alarms support safe, reliable operation, and an integrated buffer tank accommodates fluctuating flow rates. The units are housed in a splash-proof, brushed stainless steel enclosure and are specified for maximum inlet pressures of 20 bar and maximum outlet pressures of 10 bar.

Pressure regulation and backflow protection

WITT will also highlight its dome pressure regulators, which use optimized pilot pressure regulators to maintain stable working pressure as flow rates and inlet pressures change. The company links that stability to consistent process performance and product quality, and notes that the improvements can be retrofitted to existing WITT dome pressure regulators without replacing the complete system.

On the safety side, the company is presenting ULTRA non-return valves and ULTRAVENT safety relief valves. ULTRA non-return valves are described as combining low opening pressures, tight sealing and minimal flow resistance to protect gas systems against unwanted backflow. ULTRAVENT safety relief valves are designed to protect against excessive pressure and respond to pressure increases as low as 5 mbar.

At the booth

At Booth S46114, WITT says it will discuss the three product families and the functions it assigns to them: precise mixing, stable pressure and protection of the surrounding gas system.

MA

Mateo Alvarez

Mateo Alvarez covers hydraulic systems, undercarriage components, final drives, and fleet reliability for construction equipment readers. The analysis uses published hydraulic pressure and flow data, wear measurements, service interval records, and availability figures under stated machine configurations and operating conditions. It helps fleet managers, maintenance engineers, and equipment buyers plan service, compare replacement components, and reduce unplanned downtime on earthmoving and lifting fleets.